Mist Nozzle Kit
for DR-2000
 
Less frequent battery replacement compared to competitors' product
Comes in metal or plastic
Two plastic nozzles can be run from one dispenser; simply attach a "T" fitting to split the feed line to two nozzles
Useful for a variety of applications, from deoderizing to biocide
Lower cost than most competing products
Internal screen to prevent impurities from clogging nozzle
   
Model

Description

Code No.
Plastic Mist Nozzle Kit Comes with norprene sanitizer size pump tube and fittings to attach to transport line 069254
Metal Mist Nozzle Kit Comes with norprene detergent size tube and fittings to attach to transport line 069441
Plastic Mist Nozzle Kit No pump tube included 1205256

Specifications

All specfications are based on water tests. Results may vary due to varying chemical viscosities or tubing variances.

Screen mesh: 200 wires/inch

Spray length, held horizontally: 42" with metal nozzle, 24" with plastic nozzle, 20" if 2 plastic nozzles
Spray diameter, held horizontally: 18" with metal nozzle (20" distance from nozzle), 18" with plastic nozzle (14" distance from nozzle), 10" with 2 plastic nozzles (10" distance from nozzle)

Spray height, pointing up vertically: 38" with metal nozzle, 15" with plastic nozzle, 10" with 2 plastic nozzles

Approximate flow rates: 126 ml/min with metal nozzle & detergent tube, 96 ml/min with plastic nozzle and sanitizer size tube

Tube life info: Sanitizer tubes are needed with the plastic nozzles. You may use detergent tubes if the run time is extremely short, but we do not recommend this because the back-pressure will drastically reduce tube life. The detergent tube would, however, increase flow by about 20%. Using 2 plastic nozzles will increase pump tube life due to reduced backpressure, and in this case the detergent tube is suitable. With the metal nozzle, a detergent-size tube is suitable.

These specifications are subject to change without notice. Specifications for 2 plastic nozzles refer to feeding 2 plastic nozzles from one DR1000; in the test the transport tube ran about 4' to the "T" tube fitting, and then 28" to the nozzles on each side.

Home | FAQs | Documents | News & Events|Contact Us

2841 Mission St., Santa Cruz CA 95060 USA
Customer Service: (831) 426-0882 : Toll Free in USA: (800) 858-2382 :Fax: (831) 423-4573
Technical Support: (262) 631-4460 or (262) 631-4461: Toll Free in USA: (800) 468-4893 : Fax: (410) 943-1545

Copyright © 2007 Beta Technology All Rights Reserved